CheetahLab CheetahLab
DE EN

SKÅDIS holder for grease and oil

The maintenance duo hangs within reach on the pegboard instead of vanishing into a drawer.

Two grey holders on the wooden surface in front of the black pegboard, behind them the Super Lube and Synco Lube bottles and a green grease gun
Two grey holders on the wooden surface in front of the black pegboard, behind them the Super Lube and Synco Lube bottles and a green grease gun Overview graphic of the model: three variants of the holder, labelled The grey holder on the workbench, behind it the Super Lube and Synco Lube bottles The two-well holder at an angle from the front, the pegboard hooks standing out at the back The variant with three wells, one of them smaller The same variant photographed flatter in front of the black pegboard
Material
PLA
Layer height
0,2 mm
Print time
50 min – 1 h

Axles and lead screws want a bit of grease now and then. What stops you is rarely the work — it's hunting for the tube.

This holder takes the usual maintenance duo and hangs it on the SKÅDIS board: Super Lube grease with PTFE (85 g) and Synco Lube oil (118 ml). Both stand upright, neither tips over, and both are one grab away.

Three variants

A — Standard. Grease and oil.

B — Plus. Adds a bay for the EZ-Z Luber, so the Z-screw helper hangs right next to the grease. The Luber itself isn't mine and isn't part of the download — this is only the holder.

C — Applicator. Asked for by the community: a slot for an applicator or needle bottle around 32 mm across, for everyone who decants the oil instead of working from the original bottle.

Applicator bottles vary a little between makers. This variant is built for 32 mm — measure yours before you print.

Printing

View on MakerWorld