Skip to content

3D Printing

Out of everyday need, and occasional desperation

Hooked on 3D printing since mid-2023: functional parts for my own use at first, then designs of my own. I show them here because good small solutions tend to help other people too — mostly practical improvements, sometimes problems that would not exist without a printer in the house. The print files live on MakerWorld and Makeronline; a few models are available on MakerWorld only.

The grey grille head-on in front of the pegboard, the honeycomb pattern in the inner ring

Ventilation grille Ø 160 for EPP ducts

PETG · ca. 3,5 h

Two mounts in grey and white in front of the pegboard, the black Reolink camera next to them

Wall and shelf mount for the Reolink E1

PLA · ca. 2 h

The grey holder hangs on the pegboard with the green build plate cleaner and its brush standing in it

SKÅDIS holder for the build plate cleaner

PLA · ca. 1 h

Both variants side by side: on the left the plain cup, on the right the one with the embossed TAKE ONE and cards in the tray

Business card holder with pen cup

PLA · ca. 3 h

The green frame from above at an angle on the workbench, the cross in the middle and the vented sides visible

PlateCool Frame — cooling rack for print plates

PETG · ca. 4 h

The black station with the Brother label printer on the left, next to it nine TZe tape cassettes in their bays

P-touch organizer for printer and tapes

PLA · ca. 8 h

Two blue boxes with ribbed lids on the cutting mat, one open and filled with orange silica gel beads

Silica gel dry box for filament crates

PLA · 2,4–3 h

Two grey holders on the wooden surface in front of the black pegboard, behind them the Super Lube and Synco Lube bottles and a green grease gun

SKÅDIS holder for grease and oil

PLA · 50 min – 1 h

The 10-inch rack from the front: two switches, a patch panel and the black panel with pale and blue patch cables routed through it

Cable management panel for 10-inch racks

PETG · ca. 1 h

The green squeezer with a paw print sits on a cat food pouch, the pouch lying on a wooden board

Food squeezer for wet food pouches

PLA+ oder PETG · 39–52 min

Four black filament spools on the Kobra X spool holder; the front tube carries the green sleeve with its wide lip

Anti-wobble spool sleeve for the Kobra X

PLA · ca. 53 min

The black air purifier stands on the round wall shelf against a white wall, the cable leaving the channel at the bottom

Round wall shelf “AirLift 230”

PLA · 8,6–8,7 h