SKÅDIS holder for the build plate cleaner
The cleaner gets a fixed spot on the pegboard — lying flat, not upright.
- Material
- PLA
- Layer height
- 0,2 mm
- Print time
- ca. 1 h
The build plate cleaner otherwise lives somewhere on the desk, usually in the spot where you aren't looking for it.
This holder gives it a fixed place on the SKÅDIS board — lying flat, not upright. Two hooks carry it, and the ribbed bed keeps the cleaner from sliding around inside. It still comes out in one motion, without jamming.
Tested on the original IKEA board and on printed SKÅDIS panels — the hole spacing is the same, the material thickness isn't always.
The cleaner itself isn't mine. It comes from K-Studio.ca and isn't part of this download; what's here is the parking spot for it.
Printing
- 0.2 mm layer height, 3 wall lines
- Arachne wall generator
- minimal supports for the two hooks — tree, build plate only
- add a brim if adhesion is poor