Business card holder with pen cup

Two things that lie around on every counter, in one part.

Both variants side by side: on the left the plain cup, on the right the one with the embossed TAKE ONE and cards in the tray

The TAKE ONE variant from the front, four blue pens in the cup, white cards in the tray

The TAKE ONE variant from the side on the wooden surface

The plain variant at an angle from the front, pens in the cup and cards beside it

Labelled comparison: on the left the variant without lettering, on the right the one with TAKE ONE

Material: PLA
Layer height: 0,2 mm
Print time: ca. 3 h

There are always the same two things lying around on a counter: a few pens and a stack of business cards. Usually both loose.

This is both in one part — a cup for the pens and a side tray for cards at 85 × 55 mm. Meant for reception desks, practices, clubs, trade show stands: anywhere you'd like to say “please, take one” without having to say it every time.

Two variants

TakeOne carries an embossed TAKE ONE on the front. That's the version that speaks for itself.

Clean is the same shape without the text. It was added on request — not every counter suits an announcement in capital letters, and a doctor's waiting room reads differently from a trade show stand.

Printing

0.2 mm layer height, 2 wall lines
15 % infill, grid
Z seam at the back
no supports; add a brim if adhesion is poor

View on MakerWorld View on Makeronline